Detection mechanisms for low mass bosonic dark matter candidates, such the axion or hidden photon, leverage potential interactions with electromagnetic fields, whereby the dark matter (of unknown mass) on rare occasion converts into a single photon. Current dark matter searches operating at microwave frequencies use a resonant cavity to coherently accumulate the field sourced by the dark matter and a near standard quantum limited (SQL) linear amplifier to read out the cavity signal. To further increase sensitivity to the dark matter signal, sub-SQL detection techniques are required. Here we report the development of a novel microwave photon counting technique and a new exclusion limit on hidden photon dark matter. We operate a superconducting qubit to make repeated quantum non-demolition measurements of cavity photons and apply a hidden Markov model analysis to reduce the noise to 15.7 dB below the quantum limit, with overall detector performance limited by a residual background of real photons. With the present device, we perform a hidden photon search and constrain the kinetic mixing angle to $\epsilon \leq 1.68 \times 10^{-15}$ in a band around 6.011 GHz (24.86 $\mu$eV) with an integration time of 8.33 s. This demonstrated noise reduction technique enables future dark matter searches to be sped up by a factor of 1300. By coupling a qubit to an arbitrary quantum sensor, more general sub-SQL metrology is possible with the techniques presented in this work.
Main idea
A superconducting qubit is used to count photons deposited in a microwave cavity. This is used as a sensor for dark matter candidates that would potentially convert into light.
Background
Certain dark matter candidates could produce light in the microwave regime that can be captured in a resonant microwave cavity. The typical technique is to amplify the cavity signal to measure the presence of this small amount of light. This however, is subject to the standard quantum limit (a manifestation of the Heisenberg uncertainty principle), which means the noise level is around the one photon level. This is too large to measure small signals expected from the dark matter. In this work, rather than amplify both the in phase and out of phase components of the electric field in the cavity, the authors count the photons present. This results in maximun uncertainty in the phase information of the cavity state, but very accurate information about the cavity amplitude.
Results
Counting photons is an improvement over the linear amplification techniques that are typically used for this type of dark matter detection. The authors take advantage of the quantum non demolition nature of the qubit-cavity interaction to measure the cavity photons many times without destroying it. This makes it possible to be very certain about the presence of a photon even amongst the various experimental and device errors that could occur. The noise achieved in this experiement, is 1,300 times lower than a quantum limited amplification readout.